To initially configure your Ring scanner for batch number barcode scanning, you need to scan the following 2 barcodes (please ensure you are connected to the scanner via Bluetooth before scanning these . . To pair the scanner, put scanner into pairing mode by Long Pressing the trigger for 8 seconds)
Note: you will hear a BEEP once the barcode has been scanned.
![](https://s3.amazonaws.com/cdn.freshdesk.com/data/helpdesk/attachments/production/82531448/original/pMyP5YAOj8rJeEaCn5D5RsDv2YitBqpDaA.png?1717673494)
Your Ring scanner is now setup.
If you need to reset your scanner to factory defaults, scan the barcode below.
Note, you will need to pair your scanner again with your tablet after this reset.
RESET SCANNER